invalid password是什么意思
invalid password [计] 无效密码[计] 无效口令网络释义 专业释义专业:动力与电气工程|计算机科学技术非法口令以上统计来源于2,447,534篇论文数据,部分数据来源于: NoteExpress双语例句1.Another example of an alternative flow is an invalid password.可选流程的另一个例子是无效的密码。
2.Attempt to use either an invalid user ID or an invalid password to connect.尝试使用无效的用户 ID 或无效的密码进行连接。
3.This algorithm resulted in security logs filling up with "invalid password" logonattempts. 此算法会导致安全日志填满,与密码无效的登录尝试。
怎么补全以下的JS代码????
补全后的代码如下:function getSecret(file,secretPassword) {file.opened = file.opened +1;if (secretPassword == file.password) {return file.contents;} else {return "Invalid password! No secret for you.";}}function setSecret(file,secretPassword, secret) {if (secretPassword == file.password) {file.opened = 0;file.contents = secret;}}var superSecretFile = {level: "classified",opened: 0,password: 2,contents: "Dr.Evel's next meeting is in Detroit."};var secret = getSecret(superSecretFile, 2);console.log(secret);setSecret(superSecretFile, 2, "Dr.Evels next meeting is in philadelphia.");secret = getSecret(superSecretFile, 2);console.log(secret);
08611是什么错误
IBM错误故障代码:Symptom / Error (开机错误代码) FRU / Action in Sequence(检查范围及解决方法) 10X 101: Interrupt failure;(中断故障)102: Timer failure;(计时器故障) 103: Timer interrupt failure; (计时器中断故障)104: Protected mode failure; (保护模式故障) 105: Last 8042 command not accepted;107: NMI test failure;(NMI 测试失败) 108: Timer bus test failure. 109: Low meg-chip select test. 1. System board. (主板问题) 110 :(Planar parity.) (内存奇偶校验出错) 1. Go to Memory Checkout 2. DIMM card. 3. Detach the expansion unit if it is attached to the computer.4. System board. 111:(I/O parity.) 1. Go to Memory Checkout2. Expansion unit or port replicator. 3. System board.11XX 1101: Serial_A test failure.(A 串行口测试失败) 1. Serial device (串行设备) 2. Communication cable (相关通讯电缆)3. System board (主板) 12XX 1201: Serial_B test failure.(B 串行口测试失败) 1. System board (infrared) (检查主板:红外线口) 158 :(Hard disk password was not set even though the supervisor password is set.) (超 级用户密码已设,但硬盘密码没有设置) 1. Set the password for hard disk drive.(设置硬盘密码) 159 :(Hard disk password is not set the same as the supervisor password.) (硬盘密码与 超级用户密码不一样) 1. Set the correct password for hard disk drive.(设置正确的硬盘密码) 161:(Dead battery.) (CMOS 电池不行) 1. Go to Checking the Backup Battery 2. Backup battery.(CMOS 备份电池,在内存插槽旁边)3. System board. (主板) 163:(Time and date were not set.) (系统时间没有设好或混乱) 1. Set time and date.(设置正确的系 统时间) 2. System board. (主板问题) 173:(Configuration data was lost.) (CMOS 设备配置信息丢失) 1. Select OK in the err or screen; then set the time and date.(在 开机 ERROR 画面上按OK,然后设置系统时间) 2. Backup battery. (CMOS 电池需要更换)3. System board. (主板问题) 174:(Configuration error: Perform Checking the Installed Devices List before changin g any FRUs.) 1. Check device configuration.2. Hard disk drive assembly. 3. System board. 175177178175: EEPROM CRC #1 error. 177: Supervisor password check sum error. 178: EEPROM is not functional. 1. System board. (检查主板) 17XX 1701: Hard disk controller failure. (硬盘控制器故障) 1780, 1790: Hard disk 0 error. (主硬盘有问题) 1781, 1791: Hard disk 1 error.(从硬盘有问题) 1. Hard disk drive (检查硬盘) 2. System board (检查主板)183 :(Incorrect password entered at the supervisor password prompt.) (超级用户开机密码不对) 1. Have the user examine the password.(请用户检查密码) 184:(Power-on password check sum error.) (Power-on 密码有误) 1. Reset the power-on password in Easy-Setup.(重设Power-on 密码) 185:(The startup sequence is not valid. Suspect that power was off when the startup sequence was being updated.) (系统启动顺序无效,怀疑是更新启动顺序时电源关掉) 1 . Reset the startup sequence in Easy-Setup.(在Easy-Setup 重设启动顺序) 186 :1. System board. (检查主板) 190:(A depleted battery pack was installed when the power was on.) (开机时,机内笔记本电池已快耗尽了) 1. Go to Checking the Battery Pack.(更换机内笔记本电池) 191XX:(PM initialization error.) (PM 初始化错误) 1. System board. (检查主板) 192:(Fan error.) (CPU 散热风扇故障) 1. Measure the voltage of the backup battery. If the voltage is not correct, replace the backup battery.(检查CMOS 备份电池的电压,电压不行时更换电池) 2. Fan (要更换CPU风扇)3. System board (主板问题) 195:(The configuration read from the hibernation area does not match the actual conf iguration.) (从休眠区域读到的系统配置信息与实际配置不同) 1. Check if the config uration was changed. For example, check if the DIMM card is added. (检查配置是否改动,内存有无增加等) 196:(A read error occurred in the hibernation area of the hard disk drive.) ( 从硬盘的休眠区域中读写时,发生错误) 1. Run the hard disk drive test. (测试硬盘) 2. Hard disk drive.(检查硬盘) 199XX(Resume error.) 1. System board. 1XX 1. System board. 2XX (内存问题)201: Memory data error. 202: Memory line error 00-15.203: Memory line error 16-23. 205: Memory test failure on on-boardmemory. 221: ROM to RAM remap error. 1. Go to Memory Checkout.2. DIMM card. 3. System board. 225 (Unsupported memory module.) 1. Check if the supported DIMM is installed. 2. DIMM card.3. System board. 301, 303, 304, 305, 3XX (301: Keyboard error.) (笔记本键盘故障,301这个故障经常出现,往往是笔记本刚开机时,不小心 按住键盘所造成的,一般只要重启电...
京瓷5501i复印机连网络扫描报1102
是SMB故障, 用户名 密码 计算机IP地址 共享文件夹名 没有设置正确造成的 就是这几个原因 如果计算机没有密码的话 添加一个密码,按你的描述也可能是网络路径或者名称的问题,你试试。
1102SMB(SMB)Error: User/Password or SharedName/FolderNameDomain name not entered as Domain UserInput User Name with one of the form "Domain\User", "Domain/User", "User@Domain"SMB)User Name/Password or Shared Name/Folder Name ErrorSpecify invalid User/Password (includes unspecified)Input correct User Name/PasswordSpecify the User who is not permitted for accessing to the folderInput correct User and PasswordCheck access limit for send destination folderSpecify invalid Shared NameInput correct Shared Name(See the reference for the symbol which is possible to use for Shared Name)Host Name ErrorCheck if any prohibited letter (see the reference) for Host Name is included or notSCAN TO EMAIL(SCAN TO EMAIL)User Name/Password ErrorUser ID for Authentication is not entered/entered wrong User IDWrong Password for Authentication is enteredInput User ID/Password which is used for Authentication from [Advanced] on Command Center correctly([Login User Name] on [POP3] page or [SMTP] page)
[Err] 1294
执行创表语句:DROP TABLE IF EXISTS `seller`;CREATE TABLE `seller` (`id` bigint(11) NOT NULL AUTO_INCREMENT,`phone` varchar(120) NOT NULL COMMENT '手机号',`password` varchar(120) DEFAULT NULL,`create_time` timestamp NOT NULL DEFAULT CURRENT_TIMESTAMP,`update_time` timestamp NOT NULL DEFAULT CURRENT_TIMESTAMP ON UPDATE CURRENT_TIMESTAMP,`xvp_store_id` bigint(11) DEFAULT NULL COMMENT '小V铺的店铺id',PRIMARY KEY (`id`)) ENGINE=InnoDB AUTO_INCREMENT=86358 DEFAULT charset=utf-8 COMMENT='卖家账户信息';错误代码: 1293Incorrect table definition; there can be only one TIMESTAMP column with CURRENT_TIMESTAMP in DEFAULT or ON UPDATE clause解决方法:第一步、改变timestamp类型字段,只存在一个,另一个用datetime类型;第二部、用触发器:DROP TRIGGER IF EXISTS `update_seller_trigger`;DELIMITER //CREATE TRIGGER `update_seller_trigger` BEFORE UPDATE ON `seller`FOR EACH ROW SET NEW.`update_time` = NOW()//DELIMITER ;效果一样
转载请注明出处51数据库 » invalid password for